商用無料の写真検索さん
           


The vacuum forming machine, forming the dome for Calvin's model : 無料・フリー素材/写真

The vacuum forming machine, forming the dome for Calvin's model / Jordanhill School D&T Dept
このタグをブログ記事に貼り付けてください。
トリミング(切り除き):
使用画像:     注:元画像によっては、全ての大きさが同じ場合があります。
サイズ:横      位置:上から 左から 写真をドラッグしても調整できます。
あなたのブログで、ぜひこのサービスを紹介してください!(^^
The vacuum forming machine, forming the dome for Calvin's model

QRコード

ライセンスクリエイティブ・コモンズ 表示 2.0 一般
説明Calvin is in the final stages of manufacture of component parts for his lamp model. He will be using polystyrene to create a hemispherical dome for the top of his lamp. This will emerge from a hole cut out of pine 'furniture board' and this in turn will enable the dome to attach to the central cylindrical form of the bottom part of the lamp. This central cylinder is made from aluminium sheet which has been pop rivited together. Seven holes have been drilled around the circumference of the aluminium and these will accomodate nylon spikes that have been turned on the metalwork lathe. These will be attached using epoxy resin adhesive. These spikes have been counter-bored with a step drill so that the light will be transmitted along the nylon to the end of the spike. An energy efficient bulb and holder will be mounted on a wooden base at the bottom of the aluminium section.Calvin has worked extremely hard over the last few weeks and has easily risen to each and every challenge that his concept has generated along the way. Even the creation of the mdf former created issues by Calvin persevered with steely determination and kep at it until he was satisfied with the results. Good work, looking forward to seeing the completed model.
撮影日2010-02-09 18:06:02
撮影者Jordanhill School D&T Dept
タグ
撮影地
カメラNIKON D80 , NIKON CORPORATION
露出0.017 sec (1/60)
開放F値f/5.6
焦点距離20 mm


© 名入れギフト.com

こちらもおすすめです→ カエレバ(同一商品の複数ショップリンク一発作成) | Amazon search | 楽々お任せリンク | Affiliate Helper